10.3 Installing Dante Controller on Mac OS
To install Dante Controller you will need to be logged on with administrator privileges.
You do not have to uninstall the previous version before installing this update.
Do the following to install the Dante Controller:
1. Log on to your computer as an administrator.
2. Double-click the downloaded Dante Controller installer file.
3. A drive icon will appear on your Desktop Finder window. Double-click it to open.
4. Double-click the Dante Controller.pkg file. This will run the installer.
5. Read the license text, and if you accept the terms of the agreement, click Agree.
6. If you do not accept these terms, click Disagree to terminate the installation.
7. Dante Controller software has been installed. Refer to section 11.0,
"Configuring
the FPX6000 with the Dante Controller"
on page 15.
11.0 Configuring the FPX6000 with the Dante Controller
All Dante devices have transmit (Tx) or receive (Rx) channels. Receiver channels and
devices are listed down the left side of the grid (see
figure
12). Transmitter channels
and devices are listed along the top of the grid.
Figure 12.
Dante Controller Transmitter and Receiver channels
FPX6000 Quick Start Guide
15