Montigo PL60VO Installation & Maintenance Manual page 32

Page 32
Lighting Instruction Updates Lighting Instruction Updates Lighting Instruction Updates Lighting Instruction Updates
Replace the warning label with danger label in the Replace the warning label with danger label in the Replace the warning label with danger label in the Replace the warning label with danger label in the
FOR YOUR SAFETY - READ BEFORE LIGHTING:
Lighting instructions Lighting instructions Lighting instructions Lighting instructions
WARNING If the information in these instructions are not followed
exactly, a fire or explosion may result causing property damage,
personal injury or death.
WARNING / CAUTION: Hot while in operation. Do not touch.
Severe burns may result. Keep children, clothing, furniture,
gasoline and other liquids having flammable vapors away.
See installation and operating instructions accompanying this appliance.
A. This appliance has a pilot which is lit automatically. Do
not attempt to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
■ Do not try to light the appliance.
■ Do not touch any electrical switch. Do not use any
phone in your building.
■ Immediately call your gas supplier from a
neighbour's phone. Follow the gas suppliers
instructions.
LIGHTING INSTRUCTIONS:
1. STOP! Read the safety information above on this label.
2. Turn the fireplace "OFF" using the wall switch or remote
control.
3. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
4. Turn the fireplace "ON" using the wall switch or remote
control.
NOTE: This unit is equipped with an ignition system
that lights the pilot burner automatically. Do not
attempt to light the pilot by hand.
This unit is equipped with advanced safety
controls. The fireplace will not turn on until all
of the safety conditions are met.
TO TURN OFF GAS TO APPLIANCE:
1. Turn the fireplace off using the wall switch or remote
control.
2. Turn off all electrical power to the appliance.
■ If you cannot reach your gas supplier, call the Fire
Department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it. Call a qualified service
technician. Force or attempt to repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
5. Once the predetermined airflow is established in the
firebox. The hot surface igniter will start to glow. The pilot
will light up, followed by the main burner. The fireplace
will then start up.
NOTE: If the igniter does not glow, even after 3 minutes
have passed, follow the instructions "To Turn Off
Gas To Appliance" and call your service
technician or Montigo dealer.
3. Locate the gas shut off valve for the appliance and
turn off.
Operation
XG0219 - 170829