Operating The Fireplace - Montigo PL60VO Installation & Maintenance Manual

Operating the Fireplace
The unit is controlled using the ON/OFF switch at the side of the
control box or by using the optional remote control (RXM5010VO).
When placed in the ON position the fans will initialize, the igniter will
start to glow and the pilot will light, followed by the main burner.
When placed in the OFF position the flame and fans will turn off.
If the fireplace does not light after two attempts it will go into a safety
lock-out mode. After five minutes the fireplace will attempt to light
again. If the fireplace will not light, turn the fireplace off, turn off all the
electrical power to the appliance, locate the gas shut off valve and turn
the gas off. Call your service technician or local Montigo dealer. Never
attempt to light the pilot by hand.
This fireplace includes a screen barrier which helps prevent injury from
burns. Never operate this appliance without the screen attached. Children
and other at risk individuals should be monitored at all times.
Operation Suggestions
• If on a windy day the fireplace flame goes out unexpectedly while
the fan is set at high speed, toggle switch to slow speed. The flame
should relight.
INTRODUCTION
• If on a calm day you prefer warmth spread farther from the fireplace,
switch may be set to high speed.
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system
• If on a cold morning the fireplace doesn't light on slow speed,
heating appliances. The system can be operated manually from the transmitter. The system operates on radio frequenci
switch to high speed until the fireplace is warm, then switch back to
a 20-foot range using non-directional signals. The system operates one of 1,048,576 security codes that are programme
low speed.
transmitter at the factory; the remote receiver's code must be matched to that of the transmitter prior to initial use.
ON
OFF
FRONT
XG0219 - 170829
1
8
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
BATTERY
BATTERY
COMPARTMENT
COMPARTMENT
BACK
5
6
Operating the Accent Lights
The accent lighting is operated by the LED remote control. See LED
Remote Control Operation section for detailed instructions.
Model: 5010
ATTEMPT TO INSTALL OR OPERATE
The transmitter operates on 4 AAA-size 1.5V batteries. It is recommended t
Follow all warnings and instructions when using the appliance
ALKALINE batteries always be used for longer battery life and maximum op
performance. IMPORTANT: New or fully charged batteries are essential fo
operation of the multi-function transmitter. Insert 4 AAA-size 1.5 V batteries
battery compartment on the back of the transmitter, positioning the (+) and (
batteries as indicated on the casing. When the batteries are inserted, the sc
(with similar numbers) will display.
Note: On initial start up if a LOW battery icon appears on
the screen, check the position of the batteries.
Note: Due to the sensitive temperature-monitoring
components in the transmitter, it may be necessary to
allow the transmitter to stabilize to room temperature
before accurate room temperatures are displayed on
the screen. If the transmitter is activated from a
severe cold condition, it can take up to fifteen minutes
for accurate temperature readings to appear.
Operation
ON
Indicating light
Speed+
Brightness+
Brightness-
Speed-
CAUTION
Off
Color ring
Mode+
Mode-
O
O
Page 31