Table of Contents
Advertisement
Push the UltraPhase 2 detergent
cartridge into compartment 2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
"TwinDos" set. Can be changed in
"Settings".
Confirm with the OK sensor button.
Close the TwinDos flap.
5. Starting the calibration
program
For optimum water and energy
consumption and excellent wash
results, it is important to calibrate the
washing machine.
To do this, the Normal program must
be run without laundry and without
detergent.
No other programs can be started until
calibration has been carried out.
The following message appears in the
display:
Open and run "Normal", "Hot +" without
laundry.
Before using for the first time
Touch the sensor button until the
OK sensor button lights up and
confirm with OK.
Turn on the faucet.
Touch the Start/Add laundry sensor
button.
The washing machine calibration
program has started. It will take
approximately 2 hours.
At the end of the program the following
message will appear in the display:
Set up complete
Take hold of the door and pull it
open.
Useful tip: Leave the door slightly open
to allow the drum to dry.
Turn the program selector to the
position.
21
Advertisement
Table of Contents
