Advertisement
TOWER UNIT
2070 & 2250 Walk In Tower Assembly Guide
Door Frontal Fixing (Where Applicable)
Infinity
Doors supplied in accordance to
customer specific kitchen plan
Hinge Plates
Step 4.
Adjust hinge to suit. As shown below.
FRONTAL
HINGE
ADJUSTMENT
To move the
hinge up/down,
loosen screws
A + B,
Manoeuvre
the door, then
re-tighten the
screws
Page 11
Step 1.
Insert hinge into hinge holes provided, in
accordance with customers plan.
Step 2.
Align doors & frontal plinth to join together
using fixing plates (U) to the back of both
frontals. Ensure a 4mm gap is maintained
between each frontal once fixed together.
Screw in place using 4 x 15mm screws (L)
per fixing plate (U).
Step 3.
Secure hinges by tightening 2 x screws with
hinge dowels attached. These are already
positioned within the hinges.
Step 4.
Attach the door to unit, clip hinge onto
hinge plate and click to secure.
To adjust hinge using
a screw driver, tighten
or loosen as required at
points 1 & 2.
Point 1 - In - Out
Point 2 - Left - Right
A
1
2
B
To release door
Pull catch as shown,
to release hinge
from the hinge
plate.
View from Inside of Unit
50/50 & 70/30
OPTIONS
Fixing plate
U
U
Hinge dowels
Step 5.
Fit cover caps to hinge.
Adjust soft close to suit.
The top and bottom
hinges MUST be
adjusted to the SAME
STRENGTH.
1DOOR OPTION
U
U
U
U
Hinge cover caps
Advertisement
