Subscribe to Our Youtube Channel
Related Manuals for Wren Kitchens TOWER UNIT Built-in 2070 x 600 Tall
Summary of Contents for Wren Kitchens TOWER UNIT Built-in 2070 x 600 Tall
- Page 1 TOWER UNIT 600 Feature unit, Open Shelf, Wine Rack, Plate Rack Assembly Guide Built-in 2070 x 600 Tall Built-in 2250 x 600 Tall For Internal Use: FI.WR.INS.093_WKIN00220_TOWER_Feature_Aperture_Assembly_Rev4...
- Page 2 TOWER UNIT 600 Feature unit, Open Shelf, Wine Rack, Plate Rack Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Door Safe Prior to installation, fixtures including doors, drawers and loose shelves should be removed to ensure a safe installation.
- Page 3 Leg position diagram Front legs should have flat edge to the front Front Front Base Unit A Step 1. Step 2 Secure each of the legs into place with Push leg firmly down into leg base. 4 x 15mm screws (L) per leg. Ensure legs Adjust legs to 155mm before turning unit are rotated as shown so that part of it is upright.
- Page 4 TOWER UNIT 600 Feature unit, Open Shelf, Wine Rack, Plate Rack Assembly Guide Step 3. Screw into any side units using the 30mm screws (K) provided to secure to the unit. Screw just to the rear of the hinge mounting plate at the top and bottom of both sides of the unit, place a cover cap (M) on the heads to conceal them.
- Page 5 Step 7. Care to be taken. Hanging procedure Hanging brackets steps a,b & c to be carried out on both is necessary for a safe installation. sides of top unit (C) as shown. Detail B Detail B Detail B Step a Step b Step c Insert hanging...
- Page 6 TOWER UNIT 600 Feature unit, Open Shelf, Wine Rack, Plate Rack Assembly Guide Step 10. Measure appropriately and attach the 2 x hanging bracket plates onto the wall screwing through the provided holes into your wall. Screws for fixing to walls are not provided as these vary depending on your wall material and construction.
- Page 7 Step 14. Screw into any side units using the provided 2 x 30mm screws (K) to secure the unit. Screw just to the rear of the hinge plate then place a cover cap on the head to conceal it. 18mm T o p Detail D Step 15.
- Page 8 TOWER UNIT 600 Feature unit, Open Shelf, Wine Rack, Plate Rack Assembly Guide Hinge dowels Step 16. Insert hinges into hinge holes provided, in accordance with customer specific kitchen plan. Step 17. Secure hinges with the 2 x screws already located in the hinges.
- Page 9 Standard Drawer & Deep Drawer Drawer Adjustment (where applicable) Infinity + / Infinity Drawers supplied in accordance to customer Drawers supplied in accordance to customer specific kitchen plan. specific kitchen plan. Drawer frontal adjustment 2b 2a Screw point 1 as shown to adjust drawer frontal right &...
Need help?
Do you have a question about the TOWER UNIT Built-in 2070 x 600 Tall and is the answer not in the manual?
Questions and answers