Table of Contents
Advertisement
| Installing the Switch
C
3
HAPTER
Connecting to a Power Source
SFP transceivers are hot-swappable. The switch does not need to
N
:
OTE
be powered off before installing or removing a transceiver. However,
always first disconnect the network cable before removing a
transceiver.
SFP transceivers are not provided in the switch package.
N
:
OTE
C
ONNECTING TO A
To connect a switch to a power source:
First verify that the external AC power supply can provide 100 to 240 VAC,
1.
50-60 Hz, 2 A minimum.
Figure 15: Power Socket
Plug the other end of the cable into a grounded, 3-pin, AC power source.
2.
For International use, you may need to change the AC line cord.
N
:
OTE
You must use a line cord set that has been approved for the socket type
in your country.
Insert the power cable plug directly into the socket located at the back of
3.
the device.
Check the front-panel LEDs as the device is powered on to be sure the PWR
4.
LED is lit. If not, check that the power cable is correctly plugged in.
P
S
OWER
OURCE
– 46 –
Advertisement
Table of Contents
