Table of Contents
Advertisement
en Troubleshooting
Errors
"E:60 / -2B"
"E:35 / -10"
56
Cause
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
The water pressure is low.
The filter in the water inflow is
blocked.
The tap is turned off.
The water inlet hose is kinked
or jammed.
There is water in the base
trough.
The appliance is leaking.
The detergent drawer has not
been pushed in as far as it can
go.
The pump unit is not inserted.
Detergent dosage is too high.
Troubleshooting
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
No remedial action possible.
Clean the water inflow filter
▶
→ Page 53.
Turn on the tap.
▶
Ensure that the water inlet hose is not
▶
kinked or jammed.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 66
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 66
Push the detergent drawer in as far
▶
as it will go.
Insert the pump unit into the deter-
1.
gent drawer.
→ "Cleaning the detergent drawer",
Page 48
Push the detergent drawer in as far
2.
as it will go.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the compartment for manual dos-
ing (not for outdoor clothing,
sportswear or items stuffed with
down).
If intelligent dosing is activated, re-
▶
duce the basic dosage → Page 40.
If you dose manually, reduce the
▶
amount of detergent for the next
washing cycle with the same load.
Advertisement
Table of Contents
