Counting; Counting When Weight Of Sample Unknown; Counting When Sample Weight Is Known; Counting With A Remote Scale - Cardinal Detecto C Series Operation Manual

Counting Operation
Counting When Weight of Sample is Unknown
1. With the scale in the Weight mode, place the sample on the scale platform.
2. On the numeric keypad, enter the number of pieces in the sample.
3. While the display is blinking, press the SAMPLE SIZE key.
4. The display will change to show Sannp, and then show the average piece weight
(per 1000 pieces) and the number of pieces.
5. Add the pieces to be counted and read the total count on the PIECES display.
6. Remove the pieces from the scale.
7. Press the C /
Counting When Weight of Sample is Known
1. With the scale in the Weight mode, using the numeric keypad, enter the piece weight of
the sample.
2. Press the SAMPLE WEIGHT key.
3. Add the pieces to be counted and read the total count on the PIECES display.
4. Remove the pieces from the scale.
5. Press the C /

Counting with a Remote Scale

1. With the scale in the Weight mode, place the sample on the C Series scale platform.
2. Using the numeric keypad, enter the number of pieces in the sample.
3. While the display is blinking, press the SAMPLE SIZE key.
4. The display will change to show Sannp, and then show the average piece weight
(per 1000 pieces) and the number of pieces.
5. Place the additional pieces to be counted on the remote scale platform.
6. Press the REMOTE key, and read the total count on the PIECES display.
7. Remove the sample from the C Series platform and the pieces from the remote scale
platform.
8. Press the C /

Counting with an Insufficient Sample

IMPORTANT! If the sample weight is too small the PIECES display will show
------ (six dashes) for a few seconds and then the Insuf Sample annunciator
will illuminate. Continued use of the scale with the Insuf Sample annunciator
illuminated, will result in an "inaccurate" count. Press the C /
operation and return to the Weight mode. Increase the number of pieces for the sample and
repeat the counting operation to achieve an "accurate" count.
10
OPERATION, CONT.
key to complete the counting operation and return to the Weight mode.
key to complete the counting operation and return to the Weight mode.
key to complete the counting operation.
8526-M260-O1 Rev C  C Series Operation
key to cancel the counting