Wizard; Basic - ZyXEL Communications XGS1930-28 User Manual

Table 7 ZON Utility Fields (continued)
LABEL
IP Address
System Name
Location
Status
Controller Discovery
Serial Number
Hardware Version

4.4 Wizard

The Setup Wizard contains the following parts:

• Basic

to configure the Switch IP address, DNS server, system password, SNMP community and link
–
aggregation (trunking).
• Protection
• VLAN to create a static VLAN, assign ports to the VLAN and set the ports to tag or untag outgoing
–
frames.
• QoS to determine a port's IEEE 802.1p priority level for QoS.
–
4.4.1 Basic
In Basic, you can set up IP/DNS, set up your password, SNMP community, link aggregation, and view
finished results.
In order to set up your IP/DNS, please do the following. Click Wizard > Basic > Step 1 IP to access this
screen.
Chapter 4 Web Configurator
DESCRIPTION
This field displays the IP address of an internal interface on the discovered device that
first received a ZDP discovery request from the ZON Utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Switch does not support IP Configuration, Renew IP address and
Flash Locator LED, this field displays "Update failed", "Not support Renew IP address"
and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it is enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it will go
into the Nebula cloud management mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
to enable loop guard and broadcast storm control on the Switch and its ports.
–
XGS1930 Series User's Guide
48