Dhcpv6 Relay - ZyXEL Communications XGS1930-28 User Manual

34.5 DHCPv6 Relay

A DHCPv6 relay agent is on the same network as the DHCPv6 clients and helps forward messages
between the DHCPv6 server and clients. When a client cannot use its link-local address and a well-
known multicast address to locate a DHCPv6 server on its network, it then needs a DHCPv6 relay agent
to send a message to a DHCPv6 server that is not attached to the same network.
The DHCPv6 relay agent can add the remote identification (remote-ID) option and the interface-ID
option to the Relay-Forward DHCPv6 messages. The remote-ID option carries a user-defined string, such
as the system name. The interface-ID option provides slot number, port information and the VLAN ID to
the DHCPv6 server. The remote-ID option (if any) is stripped from the Relay-Reply messages before the
relay agent sends the packets to the clients. The DHCPv6 server copies the interface-ID option from the
Relay-Forward message into the Relay-Reply message and sends it to the relay agent. The interface-ID
should not change even after the relay agent restarts.
Use this screen to configure DHCPv6 relay settings for a specific VLAN on the Switch. Click IP Application
> DHCP > DHCPv6 > DHCPv6 Relay in the navigation panel to display the screen as shown.
Figure 205 IP Application > DHCP > DHCPv6 Relay
The following table describes the labels in this screen.
Table 145 IP Application > DHCP > DHCPv6 Relay
LABEL
VID
Helper Address
Options
Interface ID
Remote ID
Add
Cancel
Clear
Chapter 34 DHCP
DESCRIPTION
Enter the ID number of the VLAN you want to configure here.
Enter the remote DHCPv6 server address for the specified VLAN.
Select this option to have the Switch add the interface-ID option in the DHCPv6 requests from
the clients in the specified VLAN before the Switch forwards them to a DHCPv6 server.
Enter a string of up to 64 printable characters to be carried in the remote-ID option. The Switch
adds the remote-ID option in the DHCPv6 requests from the clients in the specified VLAN before
the Switch forwards them to a DHCPv6 server.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to their last saved values.
Click Clear to reset the fields to the factory defaults.
XGS1930 Series User's Guide
282