ZyXEL Communications XGS1930-28 User Manual page 307

Table 159 Management > Access Control > SNMP > User (continued)
LABEL DESCRIPTION
Security Level Select whether you want to implement authentication and/or encryption for SNMP
communication from this user. Choose:
• noauth – to use the user name as the password string to send to the SNMP manager. This is
equivalent to the Get, Set and Trap Community in SNMP v2c. This is the lowest security
level.
• auth – to implement an authentication algorithm for SNMP messages sent by this user.
• priv – to implement authentication and encryption for SNMP messages sent by this user.
This is the highest security level.
Note: The settings on the SNMP manager must be set at the same security level or
Authentication Select an authentication algorithm. MD5 (Message Digest 5) and SHA (Secure Hash Algorithm)
are hash algorithms used to authenticate SNMP data. SHA authentication is generally
considered stronger than MD5, but is slower.
Password Enter the password of up to 32 ASCII characters (except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for SNMP
user authentication.
Privacy Specify the encryption method for SNMP communication from this user. You can choose one
of the following:
• DES – Data Encryption Standard is a widely used (but breakable) method of data
encryption. It applies a 56-bit key to each 64-bit block of data.
• AES – Advanced Encryption Standard is another method for data encryption that also
uses a secret key. AES applies a 128-bit key to 128-bit blocks of data.
Password Enter the password of up to 32 ASCII characters (except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for
encrypting SNMP packets.
Group SNMP v3 adopts the concept of View-based Access Control Model (VACM) group. SNMP
managers in one group are assigned common access rights to MIBs. Specify in which SNMP
group this user is.
admin – Members of this group can perform all types of system configuration, including the
management of administrator accounts.
readwrite – Members of this group have read and write rights, meaning that the user can
create and edit the MIBs on the Switch, except the user account and AAA configuration.
readonly – Members of this group have read rights only, meaning the user can collect
information from the Switch.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to reset the fields to the factory defaults.
Index This is a read-only number identifying a login account on the Switch. Click on an index number
to view more details and edit an existing account.
Username This field displays the user name of a login account on the Switch.
Security Level This field displays whether you want to implement authentication and/or encryption for SNMP
communication with this user.
Authentication This field displays the authentication algorithm used for SNMP communication with this user.
Privacy This field displays the encryption method used for SNMP communication with this user.
Group This field displays the SNMP group to which this user belongs.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Chapter 37 Access Control
higher than the security level settings on the Switch.
XGS1930 Series User's Guide
307