Table 10 ZON Utility Fields (continued)
LABEL
IP Address
System Name
Location
Status
Controller Discovery
Serial Number
Hardware Version
IPv6 Address
4.4 Wizard
The Setup Wizard contains the following parts:
• Basic
to configure the Switch IP address, DNS server, system password, SNMP community and link
–
aggregation (trunking).
• Protection
• VLAN
to create a static VLAN, assign ports to the VLAN and set the ports to tag or untag outgoing
–
frames.
• QoS
to determine a port's IEEE 802.1p priority level for QoS.
–
Chapter 4 Web Configurator
DESCRIPTION
This field displays the IP address of an internal interface on the discovered device that
first received a ZDP discovery request from the ZON Utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Switch does not support IP Configuration, Renew IP address and
Flash Locator LED, this field displays "Update failed", "Not support Renew IP address"
and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it is enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it will go
into the Nebula cloud management mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
This field displays the IPv6 address on the discovered device that first received a ZDP
discovery request from the ZON Utility.
to enable loop guard and broadcast storm control on the Switch and its ports.
–
XMG1915 Series User's Guide
58