Dionex Reagent-Free Controller
•
3. Route the
suppressor and connect it to the cable from the Atlas or SRS
suppressor. To connect the cables, push them together.
NOTE
4. If you are installing a Dionex RFC in a DX-320, DX-500, or DX-600
system, go on to Section B.2.
5. If you are installing a Dionex RFC in a DX-120, go to Section B.3.
B.2
DX-320, DX-500, and DX-600 TTL Connections
NOTE For DX-120 TTL connections, go to Section B.3.
NOTE: If
TTL-1 OUT
is already in use,
connect the gradient
TTL cable to any
available TTL or
relay on the pump or
detector.
Figure 59. DX-320, DX-500, and DX-600 TTL Connections Overview
64
For DX-120 systems: Disconnect the suppressor power source
cable from the
SRS A
the other end of the cable from the suppressor cable. Remove the
power source cable from the DX-120 and store the cable for later
use.
cable (see Figure 58) from the Dionex RFC to the
AES/SRS
and
The EG-1
CR-TC
the
eluent
generator
(Section B.8).
connector inside the DX-120. Disconnect
cables are connected during
installation
procedure
Doc. 031880-04 1/12