Table of Contents
Advertisement
Dionex Reagent-Free Controller
2.4
Rear Panel
AES/SRS
3
4
Operation
Download
Figure 4. Dionex RFC Rear Panel
Cable(s) to Controlled Device(s)
An electrical cable for each controlled device extends from the rear panel and
connects to the device. The Dionex RFC-10 includes only the suppressor
(AES/SRS) cable. The Dionex RFC-30 (pictured) includes cables for a
suppressor (AES/SRS), an eluent generator (EG-1), and a CR-TC.
Operation/Download Button
When the
downloaded to the Dionex RFC (see Section 6.1). The
must be used for all other functions.
RS-232 Port
This port is used when downloading new Moduleware to the Dionex RFC (see
Section 6.1).
TTL Control/AC Control Button
When the
is enabled. When the
bypasses the
Contact Thermo Fisher Scientific for details.
TTL Control Input Connectors
The
Pump
cable. The pump or DX-120 then signals the Dionex RFC when the pump flow is
on. The
8
EG-1
EG-2
CR-TC
7
5
6
TTL Control
RS-232
TTL Control Input
AC Control
Pump
Gradient
position (in) is selected, new Moduleware can be
Download
position (out) is selected, the
TTL Control
AC Control
Pump
TTL input. AC control can be used with a DX-120 system.
input connects to a TTL output on the pump or to a DX-120 adapter
connector is used only with Dionex RFC-30 eluent generator
Gradient
Provides on/off control of
1
the Dionex RFC.
and Fuse Holder
2
The Dionex RFC power
cord connects here. Two
fuses are located in the
holder under the receptacle.
See Section 6.3 for how to
change fuses.
Pump
position (in) is selected, the Dionex RFC
Main Power Switch
Main Power Receptacle
Operation
position (out)
TTL input connector
Doc. 031880-04 1/12
Advertisement
Table of Contents
