Table of Contents
Advertisement
Dionex Reagent-Free Controller
1. To set the suppressor current, press
current screen (see Figure 15).
Current Range
for This
Suppressor
Figure 15. Example Suppressor Current Screen
2. Press
3. Press
current is displayed.
4. Press
ENABLED
immediately.
3.5
Dionex RFC-30 Operation
The Dionex RFC-30 can control a suppressor, an eluent generator, and a
CR-TC. The Dionex RFC-30 controls these devices by supplying current
(to the suppressor and eluent generator) and voltage (to the CR-TC).
The front panel LEDs indicate when a device is on (current or voltage is
being supplied):
RFC ENABLED
DEVICE SELECT (AES/SRS, EGC, CR-TC)
If either the
voltage is not being supplied and the device is off.
NOTE A flashing
18
. The
ENTER
SUPP CURR =
or
to increase or decrease the value, until the desired
to save the value. If the suppressor is on (i.e., the
ENTER
and the
AES/SRS
(on)
or the
RFC ENABLED
DEVICE SELECT
selected, but the pump flow is off.
or
to display the suppressor
value on the screen is highlighted.
LEDs are both on), the current is applied
(solid light on, not flashing)
LED is off, current or
DEVICE SELECT
LED indicates the device is
RFC
Doc. 031880-04 1/12
Advertisement
Table of Contents
