Table of Contents
Advertisement
Turning Off the Suppressor
To turn off the suppressor, press the
Turning off the pump automatically turns off the suppressor.
When priming the pump, turn off the suppressor. During priming, the
pump is on and the Dionex RFC is enabled, but there is no flow to the
device.
3.4
Dionex RFC-10 Setup
Before using the Dionex RFC-10 for the first time or after installing a
different suppressor type, follow the steps on page 15 to set the
suppressor type. The Dionex RFC then sets the upper limit for suppressor
current. After setting the type, set the flow rate (see page 16) and the
suppressor current (see page 17).
Setting the Dionex RFC-10 Suppressor Type
1. Press
NOTE The NONE suppressor type indicates that a type is
2. Press
The
Figure 12).
Doc. 031880-04 1/12
to display the suppressor type screen (see Figure 11).
Figure 11. Suppressor Type Screen
not selected.
.
ENTER
entry field on the screen is highlighted (see
SUPP TYPE =
Figure 12. Setting the Suppressor Type
button or turn off the pump.
AES/SRS
Operation
15
Advertisement
Table of Contents
