Shutting Down The Dionex Rfc - Thermo Scientific Dionex RFC Operator's Manual

Setting the Ion Count Percentage
1. Press
2. Press
The
3. Press
cartridge, select 100%. If you are reinstalling a used cartridge, select
the value that was displayed before the cartridge was removed.
4. Press
4.

Shutting Down the Dionex RFC

DX-120 Shutdown
Front panel control
Software control
DX-320/DX-320J Shutdown
Front panel control
Software control
DX-500/DX-600 Shutdown
Front panel control
Software control
Doc. 031880-04 1/12
 
or to display the EGC ion count screen (see Figure 41).
Figure 41. EGC Ion Count Screen
.
ENTER
value on the screen is highlighted.
ION COUNT =
 
or until the desired count is displayed. If this is a new
.
ENTER
Turn off the pump.
Turn off the pump from the software.
Set flow to 0 or
Turn off the pump motor.
Write a program or method to set the flow to 0.
This disables the TTL and shuts off current to
the suppressor.
Set the flow to 0 or
Turn off the pump motor.
Write a program or method to set the flow to 0.
This disables the TTL and shuts off current to
the suppressor.
Shutting Down the Dionex RFC
Percentage of
ions remaining
in the cartridge
37