D Message Transmission - Icom ID-800H Firmware Update

1
DIGITAL MODE OPERATION
D D Message Transmission
Select the message transmission function ON and OFF.
When ON is selected, the transceiver transmits a text mes-
sage (pre-programmed).
q Set the operating frequency, call signs and other settings,
such as repeater, as desired.
w Push [SET•LOCK] to enter message set mode.
• Rotate [DIAL] to select "MESSAG," if "CALLS" or "SET" is dis-
played.
e Push [SET•LOCK] or [S.MW•MW] several times until
"TXM-C" appears.
r Rotate [DIAL] to select the desired message channel.
• "C1" to "C6" available.
• See pgs. 18 and 19 for message programming.
t Push [S.MW•MW] to select the message transmission set-
ting, then rotate [DIAL] to select "TXM-ON."
y Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]
or [MONI•DTMF•EMR] to exit message set mode.
u Push [PTT] to transmit and send the selected message si-
multaneously.
20
SET
B
(default: OFF)
z Set the operating frequency, call signs and other
settings, such as repeater, as desired.
x Push [
B (D-OFF)] to enter message set
SET
mode.
• Push [Y Y ] or [Z Z ] to select "MESSAG" if necessary.
c Push [
B(D-OFF)] or [
SET
times until "TXM-C" appears.
v Push [Y Y ] or [Z Z ] to select the desired message
channel.
b Push [ C(T-OFF)] then [Y Y ] to select "TXM-
ENT
ON."
n Push [
A(MW)] to exit message set mode.
CLR
m Push [PTT] to transmit and send the selected
message simultaneously.
C (T-OFF)] several
ENT