Icom ID-800H Firmware Update page 6

1
DIGITAL MODE OPERATION
z Push [
SET
SET
• Push [Y Y ] or [Z Z ] to select "CALLS," if necessary.
B
x Push [
SET
times to select "UrCALL," then push [BAND].
c Push [Y Y ] or [Z Z ] to select the desired call sign
channel.
v Push [BAND] for 1 sec. to enter call sign pro-
gramming mode.
• The 1st digit blinks.
b Push [Y Y ] or [Z Z ] to select the desired character or
code.
• Push [
SET
cursor to right or left respectively.
n Push [
SET
push [Y Y ] or [Z Z ] to select the desired character or
code.
• The 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming other station call
signs.
m Push [BAND] for 1 sec. to save the call sign.
, Push [Y Y ] or [Z Z ] to select an another channel
from "U01" to "U99."
. Repeat c to m to program another station call
sign channels.
⁄0 Push [
CLR
4
B(D-OFF)] to enter call sign set mode.
B(D-OFF)] or [ C(T-OFF)] several
ENT
B(D-OFF)] or [ C(T-OFF)] to move the
ENT
B(D-OFF)] to select 2nd digit, then
A(MW)] to exit call sign set mode.
NOTE: During the call sign programming mode (v to n),
push [VFO/LOCK] to clear the entered call sign
returns to the 1st digit position)
select "CQCQCQ," "/" and the previously saved call sign.
(the cursor
, push [VFO/LOCK] again to