GEZE GC 307+ Quick Start Manual page 4

Open the GC 307+
Setting using the remote control
Operation
After unlocking, the red LED flashes
and the sensor is accessible.
Saving the access code
The access code (1 to 4 digits) is recommended for sensors which are close together.
Deleting the access code
Enter the
X
access code.
Setting one or more parameters
Select a parameter.
X
Resetting to factory settings
If the red LED flashes quickly after unlocking:
Enter the access code.
X
If the access code is not known:
Turn the power supply off and on again.
X
After switch-on the sensor can be unlocked
within 1 minute without the access code being
entered.
Full reset
Lock the sensor again at the end of the
X
settings.