Draining The Solution Tank - Ice i20NBL+ Operator's Manual

Any time scrubbing operation is completed, the solution tank should be drained and cleaned.
1. Pull the solution tank level hose (see
machine components, item #24) off
the hose fitting, this will allow the so-
lution to flow freely into a bucket or
floor drain.
2. Remove the cover of the filter assembly
(see machine components, item #30) to
drain the solution tank, check the filter
screen and clean it up if necessary.
(See Fig. 19)
i20NBL+ / i20NBTL+ / i20NBTL+-OB/ i24BTL+
OPERATOR MANUAL

Draining The Solution Tank

3. Rinse the solution tank with clean wa-
ter after every use. This will help pre-
vent chemical build up and clogging of
the solution lines.
4. After rinsing out the tank, securely re-
connect the tank level hose to the hose
fitting, replace the filter assembly cover
and be sure the filter screen and the „O"
ring is in the correct position.
Figure 19
27