Advertisement
3. L
OADING THE
Gently pop the printer cover's latch to open the cover (Figure 10); then lift the cover. Load a roll of
thermal paper (Appleton 1012 recommended) into the printer (Figure 11). Load it so that the
print-side of the paper will feed out facing the operator. Close the cover by pressing down evenly
on both side tabs, or by pressing on the center of the printer cover. Use the serrated bar to tear off
any excess paper.
4. U
M
SING THE
Magnetic Card Reader
Find the card reader slot at the right side of terminal. Slide the card in either direction through the
slot without stopping. If the card swipe fails, check the position of the magnetic stripe and slide
the card again (Figure 12).
5. U
K
SING THE
To enter numbers or letters, simply press the appropriate key. For example, to type the letter B:
Press and release [B] twice times, then display shows B (Figure 13).
6. I
NSTALLING THE
There are four SAM slots located on the left side of the device (Figure 14). Before insert the SAM
card, please turn off the device. Insert the SAM card in the slot in figure 15. Make sure SAM cards
inserted in the right direction (Figure 16).
7. I
NSTALLING THE
P
APER
Figure 10
C
AGNETIC
ARD
P
EY
AD
SAM
CARD
Figure 14
P
S
RIVACY
Figure 9
Figure 11
R
EADER
Figure 12
Figure 13
HIELD
Figure 15
Advertisement
