Advertisement
■
RP-10 power spec:
Input: 5V DC, 0.5A
Operating Temperature: 0
3. P
O
/O
OWER
N
To power on the device, please plug the USB cable into the USB port of your host terminal or
POS.
Note: When there is no action on RP‐10 after 60 seconds, the device will enter power saving
mode. Please short press any button on keypad to wake up the device.
4. U
M
SING THE
Swipe the card through the slot with magnetic stripe side facing the same direction as the
display. (Figure 3)
5. U
IC C
SING THE
Insert an IC card into the slot (Figure 4) with the chip side facing the same direction as the
touch panel (Figure 5).
o
C to 40
D
FF THE
EVICE
C
AGNETIC
ARD
R
ARD
EADER
Figure 4 Figure 5
o
C
R
EADER
Figure 3
Advertisement
