Page 2
1. P ACKAGE ONTENT xCL_AP-10 Privacy Shield (Optional) 2. D EVICE VERVIEW xCL_AP‐10 (hereunder called AP‐10) Key Buttons & Interface Ports (Figure 1): FRONT REAR Figure 1 4” TFT Color Display (480 x 800 pixel) FRONT AREA Rubber Keypad Smart Card Reader (SCR) slot Magnetic Strip Reader (MSR) slot USB cable (type A) REAR AREA ...
Page 3
USB port that that outpu ut complies with the re equirement of the Lim ited Power Source of IEC 60950‐1 / EN 60590‐ ‐1 / UL 60590‐1 / CSA 60 0950‐1 Caution: Use only the AC C adapter approved and provided by XAC Autom mation Corporation for u use with this device Caution: Risk of explosio on if the battery is repla aced by an incorrect typ pe. Please dispose of us sed battery according g to the instructions. 3. P OWER...
5. U IC C SING THE EADER Insert an IC card into the slot (Figure 3) with the chip side facing upward as the display (Figure 4). Figure 3 Figure 4 ...
Page 5
9. I SIM & SAM NSERT CARD To remove the SAM card compartment by unlocking the screw M1.6 *3 pieces, please use the screw driver type 0 (Figure 7), After removing the cover, the user can find SAM *2 slots at the bottom side of device. Please insert the card correctly as the icon shown on the cover (Figure 8): Figure 7 Figure 8 ...
Page 6
XAC Automation Corporation 886-3-577-2738 The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. ...