■ RP-10 power spec: Input: 5V DC, 0.5A Operating Temperature: 0 C to 40 C 3. P OWER FF THE EVICE To power on the device, please plug the USB cable into the USB port of your host terminal or POS. Note: When there is no action on RP‐10 after 60 seconds, the device will enter power saving mode. Please short press any button on keypad to wake up the device. 4. U SING THE AGNETIC EADER Swipe the card through the slot with magnetic stripe side facing the same direction as the ...
6. U SING THE After inserting the chip card, Press the numeric key as below keypad (Figure 6) to enter the desirable numbers. Press Cancel (X) key to terminate any current function and press the Enter (O) key to confirm a value or an option. Figure 6 7.
Page 5
Figure 10 EDERAL OMMUNICATION OMMISSION NTERFERENCE TATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 6
XAC Automation Corporation 886-3-577-2738 The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation.