Advertisement
Quick Links
Advertisement
Related Manuals for XAC XCE-25-C
Summary of Contents for XAC XCE-25-C
- Page 1 CE-25-C HIP AND OBILE AYMENT EVICE X NSTALLATION UIDE...
-
Page 2: Before Starting
Once it is powered on, the LED will blink every five seconds to indicate it is active. To power off the device, press and hold the Power key for five seconds until the screen become blank. Figure 3 NOTE: xCE-25-C will power off itself automatically if unused for 5 minutes. -
Page 3: Magnetic Card Reader
3. C ONNECTING TO MART EVICES Once xCE-25-C is powered on Bluetooth will be searchable. From the smart device’s Bluetooth settings, pair and connect to xCE-25-C. 4. U SING THE AGNETIC EADER Find the magnetic card reader slot on the right side of the device (Figure 4). Swipe the card through the slot with magnetic stripe side facing the same direction as the keypad (Figure 5). - Page 4 7. U SING THE ONTACTLESS EADER Contactless reader antenna is around the display and PIN pad. It will light up with LED signal when terminal is powered on and that means reader is working normally. Put contactless card to approach the antenna of card reader (Figure 9) for reading the card data during transaction. Figure 9...
- Page 5 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 6 XAC Automation Corporation. XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for incidental or consequential damages resulting from the furnishing, performance or use of his material.