Powering Up The Pen Table Pc; Shutting Down The System; Suspending System Operation - Fujitsu ST4120P User Manual

F u j i t s u S t y l i s t i c S T 4 1 2 0 P / 2 1 P Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
Icon Apperance Current State
On State
Power icon
or
displayed
Idle State
continuously
Suspend-to-
Power icon
RAM
blinking
Off State, or,
Power icon not
Hibernate
displayed
(Save-to-Disk )
* Information in Table 2-1 on page 20 is supplied to help you understand which system states your
system can enter from the current system state. Refer to the procedures on starting the system,
shutting down the system, suspending system operation, and resuming system operation given
later in this chapter.
Your system may be configured to use either Suspend-to-RAM mode or Hibernate mode.
POWERING UP THE PEN TABLET PC
Follow the procedure below to start the Fujitsu
Stylistic ST4120P/21P Tablet PC. Before you begin,
confirm that the system is in the Off state. To do so,
observe the Status display. If the Power icon is not
visible in the Status display, the system is in Off
state or in Hibernate (Save-to-Disk) mode and it is
safe to perform this procedure. If the Power icon is
visible (either blinking or on continuously), do not
perform this procedure. See "System States" earlier
in this chapter for details on modes represented by
the Power icon.
1. Ensure that the battery in your Pen Tablet PC is
sufficiently charged, or connect an external power
source such as the AC adapter to your Pen Tablet
PC.
2. Press the Power On/Suspend/Resume button to
start the system.
After performing initialization, the system starts the
operating system installed on the hard disk drive.
Once the operating system is running, you can use
the system.

SHUTTING DOWN THE SYSTEM

Follow these steps to shut down and turn off your
system:
20
To enter the Off state, shut down the system using the
Start menu on your system.
To enter Suspend-to-RAM or Hibernate (Save-to-Disk)
state, suspend system operation using either a hardware or
software suspend.
To enter the On state, resume system operation by
pressing the Suspend/Resume button.
To enter the Off state, resume system by pressing the
Suspend/Resume button, then shut down your system.
To enter the On state, start your system, or resume system
operation by pressing the Suspend/Resume button.
Table 2-1 Changing System States
1. If system operation has been suspended, resume
2. Save your work and close all running programs.
3. Choose Shut Down from the Windows Start
4. Carry out the Shut Down command.
The system is now in the Off state.

SUSPENDING SYSTEM OPERATION

The Pen Tablet PC allows you to suspend the
system operation without closing programs or
exiting the operating system. Use this feature to
conserve battery power when a system shutdown is
not practical or when the battery needs to be
changed.
Purpose
system operation. See "Resuming System Opera-
tion" later in this chapter for details.
menu.
If you have set your system to turn power
off from the Power Options utility in the
Control Panel, the following procedure will
not be possible, since pressing the button
shuts the system down rather than
suspending it. To change your power
options, go to Start -> Settings -> Control
Panel -> Power Options.