Agency Notices - Fujitsu Stylistic LT 800P User Manual

Agency Notices

NOTICE
Changes or modifications not expressly approved by Fujitsu could void this user's
authority to operate the equipment.
FCC NOTICES
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet that is on a different circuit than the receiver.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables must be employed with this equipment to ensure compli-
ance with the pertinent RF emission limits governing this device.
Notice to Users of the US Telephone Network
This equipment complies with Part 68 of the FCC rules, and the requirements adopted
by ACTA. On the bottom of this equipment is a label that contains, among other infor-
mation, the FCC registration number and ringer equivalence number (REN) for this
equipment; or a product identifier in the format US:AAAEQ##TXXXX. If requested,
this information or number must be provided to the telephone company.
This equipment is designed to be connected to the telephone network or premises
wiring using a standard jack type USOC RJ11C. A plug and jack used to connect this
equipment to the premises wiring and telephone network must comply with the appli-
cable FCC Part 68 rules and requirements adopted by the ACTA. A compliant tele-
phone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant.
The ringer equivalent number (REN) of this equipment is 0.0B. The REN is used to
determine the number of devices that may be connected to a telephone line. Excessive
RENs on a telephone may result in the devices not ringing in response to an incoming
A g e n c y N o t i c e s
59