Fujitsu Stylistic LT 800P User Manual page 31

If you have successfully performed this procedure, system operation is now
suspended. Refer to "Resuming System Operation" later in this chapter to resume
system operation. Also, note the following with regard to suspending system
operation:
• If the battery goes dead while the system is in Suspend-to-RAM
mode, data loss could occur. If the system will be in Suspend-to-RAM
mode for an extended period of time, be sure to have a fully charged
battery installed.
• The system is supported by a bridge battery for approximately five
minutes while the main battery is being replaced. Be sure to replace
the main battery quickly or use the AC Adapter when replacing the
battery.
• You can remove the battery pack while the system is in Suspend-to-RAM or
Save-to-Disk modes in order to install a charged battery pack. To prevent losing
unsaved data, wait until system operation has suspended before you remove the
battery pack.
• Your system may be configured to suspend operation automatically after a
period of inactivity.
• Your system may be configured to enter Save-to-Disk mode automatically after a
period of time in Suspend-to-RAM mode.
• The system uses a small amount of battery power when in Suspend-to-RAM
mode. Eventually, the battery will become fully discharged.
Note: If you will not be using the system for an extended period of time, shut
down the system rather than using Suspend-to-RAM mode.
• If the battery pack charge drops to a Low-Battery Warning level while the system
is running, the system will beep periodically. If this occurs, suspend system
operation, shut down the system, or attach an external power source, such as the
AC adapter, to the tablet.
• If the battery charge drops to a Critically Low level while the system is running,
the system is forced into a pre-selected mode (Suspend-to-RAM or Save-to-
Disk). If this occurs, you must either install a charged battery pack, or connect
an appropriate external power source such as the AC adapter before you can
resume system operation. (If the battery charge drops to a Critically Low level
while the system is in Suspend-to-RAM mode, the system stays in Suspend-to-
RAM mode until power is restored or totally dissipated.)
U s i n g Y o u r T a b l e t P C
29