Fujitsu Stylistic LT 800P User Manual page 70

S t y l i s t i c L T 8 0 0 P T a b l e t
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in accor-
dance with the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver
is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure statement
This Wireless LAN radio device has been evaluated under FCC Bulletin OET 65C and
found compliant with the requirements as set forth in CFR 47 Sections 2.1091, 2.1093,
and 15.247 (b) (4) addressing RF Exposure from radio frequency devices. The radiated
output power of this Wireless LAN device is far below the FCC radio frequency exposure
limits. Nevertheless, this device shall be used in such a manner that the potential for
human contact during normal operation is minimized. When using this device, a certain
separation distance between antenna and nearby persons must be maintained to ensure
RF exposure compliance. In order to comply with RF exposure limits established in the
ANSI C95.1 standards, the distance between the antennas and the user should not be less
than 20 cm (8 inches).
Export restrictions
This product or software contains encryption code which may not be exported or
transferred from the US or Canada without an approved US Department of Commerce
export license. This device complies with Part 15 of FCC Rules., as well as ICES 003 B /
NMB 003 B. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesirable operation. Modifications not expressly
authorized by Fujitsu PC Corporation may invalidate the user's right to operate this
equipment.
68
2
2
2