Storing The Stylistic Lt800P Tablet; Avoiding Overheating - Fujitsu Stylistic LT 800P User Manual

S t y l i s t i c L T 8 0 0 P T a b l e t
4. Apply pressure to the screen protector with your finger using a continuous
wiping motion along the edges. The adhesive sets completely within 48 hours. To
ensure a good seal between the screen protector and the display, do not lift the
screen protector from the display once it has been applied.
5. Remove the protective plastic cover from the face of the screen protector.
6. Clean any residue left behind by the protective coating from the exposed surface
of the screen protector by wiping gently with a soft cotton cloth dampened with
denatured alcohol. Wipe the screen protector with a soft dry cloth to remove any
low-tack adhesive; this will help prevent the pen tip from squeaking.

Storing the Stylistic LT800P Tablet

Be sure not to store your Stylistic LT800P with the screen side down,
otherwise damage to the display may occur.
Store your tablet in the Off state with a fully charged battery pack installed. The battery
pack always provides power to some system components, even when the system is in Off
state. If the system is stored with the battery pack removed, these components are
powered by the system's internal bridge battery. The bridge battery is not designed for
extended use and will discharge in a short period of time; this could result in damage to
the batteries. You can store the tablet in the Off state for about 30 days with a fully
charged battery pack installed. After this period, the battery pack should be recharged or
replaced with a charged battery pack.

Avoiding Overheating

The Stylistic LT800P tablet monitors its internal temperature. As the internal
temperature approaches the tolerable limits of heat-sensitive components, system
functions are automatically limited or turned off to prevent damage.
To avoid overheating the tablet, do not obstruct the air vents on the top
and bottom edges of the tablet.
46
2
2