Troubleshooting - Fujitsu Stylistic LT 800P User Manual

S t y l i s t i c L T 8 0 0 P T a b l e t

Troubleshooting

This section contains troubleshooting information, including causes and actions, for
problems you may find while using this device.
Troubleshooting Table
Problem
An exclamation
mark (!) or cross (x)
is attached to
[Intersil PRISM
Wireless LAN PCI
Card].
Other computers
are not displayed
when the [Network
Computer] icon is
double-clicked.
88
Possible Cause
A failure to
recognize the
device.
A failure in
installing the driver.
The network has
not been set up
correctly.
It takes time before
the network is
searched and the
computer
connected is
displayed.
A failure in
installing the driver.
The TCP/IP
protocol is not
installed, or, the IP
address is not set
correctly.
Possible Solution
Restart the computer.
Restart the computer.
Check the setting for the protocol, work-
group, and sharing.
To check this, you need a different proce-
dure, depending upon the operating
system that you use. Refer to the appro-
priate section of this chapter.
Perform the following steps to search for
the computer.
Click [Start] -> [Search] -> [Other
Computers].
Enter the computer name that you are
connecting to in [Name], and click
[Search].
Double-click the icon of the computer
that has been searched.
Make sure that the driver is correctly
installed.
Make sure that the TCP/IP protocol is
installed. To check this, you need a
different procedure, depending on the
operating system that you use. Refer to
the appropriate section of this manual.
11
11