Removing And Installing Memory Modules - Fujitsu Stylistic 4120 User Manual

S t y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t P C U s e r ' s G u i d e – S e c t i o n T w o
Figure 2-6. Removing a PC Card
REMOVING AND INSTALLING
MEMORY MODULES
There is one DIMM slot in your Tablet PC and 256MB
on the motherboard. 256MB and 512MB modules are
available, so you can install a combination of up to
768MB in the system.
C A U T I O N
DIMM replacement should only be performed at a
static-free workstation. Avoid touching connector pins,
circuit boards, or other circuit components on the drive
or Tablet PC. Electrostatic discharge caused by doing so
can damage sensitive components.
Installing a Memory Module
To install a DIMM module in the Tablet PC:
1. Ensure that the Tablet PC is off. To do so, carry out
the Shut Down command in the Start menu. (Do
not attempt to remove or install a DIMM module
when the system is in Suspend mode or running.)
2. Remove the two screws from the cover plate on the
back of the Tablet PC and remove the cover plate as
shown in Figure 2-7.
Figure 2-7. Accessing the Memory Slot
26
3. Insert the DIMM module in the socket at an angle
and push it down until it locks into place as shown
in Figure 2-8. Note that the DIMM module is keyed
to prevent it from being inserted backwards.
Figure 2-8. Installing a DIMM Module
4. Reinstall the cover and screws that you removed in
step 2.
5. Confirm that the DIMM module is recognized by
the system. To do so, run BIOS Setup. The size of
the DIMM module should be displayed in the Info
menu in BIOS Setup.
The DIMM module is installed in the Tablet PC and you
can now use the system.
Removing a Memory Module
To remove a DIMM module:
1. Ensure that the Tablet PC is off. To do so, carry out
the Shut Down command in the Start menu. (Do
not attempt to remove or install a DIMM module
when the system is in Suspend mode or running.)
2. Remove the screws from the cover plate on the back
of the Tablet PC and remove the cover plate as
shown in Figure 2-7.
3. Spread the fingers on the socket that lock the DIMM
module in place until the DIMM module is loose.
4. Remove the DIMM module from the socket.
The DIMM module is now removed from the Tablet PC.
Refer to "Installing a Memory Module" on page 26 to
install a new DIMM module.