Modem Connection; Pc Card Slot; Removing And Installing Memory Modules - Fujitsu ST4120P User Manual

F u j i t s u S t y l i s t i c S T 4 1 2 0 P / 2 1 P Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
• To prevent draining the bridge battery,
always store the system with a charged
battery installed.
• If the bridge battery becomes drained, it
takes approximately 8 hours for it to be fully
recharged.
• The bridge battery charges when the AC
Adapter is connected and the system is in
On or Off states or Suspend mode. It
charges from the battery only when the
system is in the On state.

MODEM CONNECTION

The Fujitsu Stylistic ST4120P/21P Tablet PC is
designed to accept a standard RJ-11
telephone plug. Connect the plug to the
modem jack located on the left-hand side of
the Pen Tablet PC (See Figure 1-4 on page 7
for location) . The telephone plug can be
installed whether or not the Pen Tablet PC has
power applied.
If you need assistance configuring the Fujitsu
Stylistic ST4120P/21P Tablet PC modem or
LAN, contact your local help desk or your
reseller.

PC CARD SLOT

The Fujitsu Stylistic ST4120P/21P Tablet PC
Card slot allows you to install a Type I or Type
II PCMCIA Card.
Installing a PC Card
To install a PC card, position the side with the
arrow facing up (i.e., when looking at the
tablet's display side, the arrow on the card
should be visible.) Slide the card into the PC
Card slot, and press it firmly to ensure proper
seating. (See Figure 2-3 for location)
If you need assistance installing a PC Card in
the Fujitsu Stylistic ST4120P/21P Tablet PC,
contact your corporate help desk or your
reseller.
Figure 2-3 Installing a PC Card
26
Removing a PC Card
To remove a PC Card, press the PC Card eject
button so that it pops out. Once the button has
popped out, press it firmly to eject the card.
(See Figure 2-4 for location)
Figure 2-4 Removing a PC Card
REMOVING AND INSTALLING
MEMORY MODULES
There is one DIMM slot in your Pen Tablet PC
and 256MB on the motherboard. 256MB and
512MB modules are available, so you can
install a combination of up to 768MB in the
system.
DIMM replacement should only be
performed at a static-free workstation.
Avoid touching connector pins, circuit
boards, or other circuit components on the
drive or Pen Tablet PC. Electrostatic
discharge caused by doing so can damage
sensitive components.