Fujitsu Stylistic 4120 User Manual page 62

S t y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t P C U s e r ' s G u i d e – A p p e n d i x
Item
Key Click the down arrow and select the input
Format for the Network key.
ASCII
characters
Hexa-
decimal
characters
Table 8: Setting parameters
8. When you finish your entry, click [OK]. [Wireless
Network Connection 2 Properties] appears again.
9. Make sure the network name you specified for the
SSID in Step 7 is added under [Preferred networks].
Network Connection
The section describes how to set the network connection
for a computer running Windows XP.
Network Settings
In this section, you set "TCP/IP Settings," and complete
"Checking Computer Name and Workgroup" required
for the network connection.
TCP/IP Settings
1. On [Wireless Network Connection Properties], click
[General].
P O I N T
If [Wireless Network Connection 2 Properties] is not
displayed, click [Start] -> [Settings] -> [Control Panel],
and double-click the [Network Connection] icon.
Right click the [Wireless Network Connection], and
then click [Properties] from the menu that appears.
52
Description
Select this when using
ASCII characters for the
Network Key. Characters
that can be used follow:
0-9, A-Z, a-z, and
_ (underscore)
Example: To set the key to
"ABC12", input "ABC12".
Select this when using
hexadecimal characters for
the Network Key.
Use this if there is a wireless
LAN card in the network
that has the Network Key
set to a character code. In
'Network Key', input the
same value as the other
wireless LAN card.
2. Perform the following steps.
Click [Internet Protocol (TCP/IP)].
Click [Properties]. [Internet Protocol (TCP/IP)
Properties] appears.
3. Set an IP address. Ask your network administrator
and check the setting.
Item
AdHoc Set the IP address and subnet mask.
Network Click [Use the following IP address].
Enter a value for [IP address] and
[Subnet mask]. See "Setting IP
Addresses" on page 58 to set IP
address and subnet mask.
For Select [Obtain an IP address
Infrastructure automatically]. For the DNS server,
Network select [Obtain DNS server address
automatically]. For the IP address,
DNS server, and default gateway,
follow the network administrator's
instructions, if any.
Table 9: Setting an IP address
5. Click [OK].
P O I N T
If you have changed the setting, [Close] is shown
instead. Click [Close].
6. Close [Network Connection].
Checking the Full Computer Name and Workgroup
1. Click [Start] -> [Control Panel]. Make sure the
Classic View is selected.
2. Double-click the [System] icon. [System Properties]
appears.
3. Click the [Computer Name] tab.
4. Check [Full computer name] and [Workgroup]. Ask
your network administrator and check the setting.
Item
Computer A name to identify the computer on
Name the network. You can specify any
name to each computer. Use up to 15
single-byte characters. For easier
identification, use the model name or
user name.
Description
Description