Before Using This Device - Fujitsu Stylistic 4120 User Manual

S t y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t P C U s e r ' s G u i d e – A p p e n d i x

BEFORE USING THIS DEVICE

Thank you for purchasing a Fujitsu ST4000 Series Tablet
PC with the optional Integrated Wireless LAN. This
manual describes the basic operating procedures for the
Wireless LAN (referred to as the "device" in this manual)
and how to set up a wireless LAN network. Before using
this device, read this manual carefully to ensure correct
operation of the device. Keep this manual in a safe place
for reference while using the device.
Characteristics of the Device
This device consists of a wireless LAN card that is
attached to the computer via a mini-PCI slot.
The main characteristics are as follows:
It uses the power saving communications system in
the 2.4 GHz band, and does not require any license for
radio communication.
It uses Direct Sequence Spread Spectrum (DS-SS),
which is resistant to noise.
This device complies with Wi-Fi, and is able to com-
municate at the maximum transfer rate of 11 Mbps.
The maximum communication range is approxi-
mately 120 feet (36.5 meters) inside a building. The
range may be shorter depending upon the installation
factors, such as walls and columns.
Unauthorized access can be prevented with the use of
SSID and encryption key.
Wireless LAN Modes Using this Device
AdHoc Mode
The "AdHoc Mode" refers to the network connecting
two computers using wireless LAN cards. This connec-
tion is called an "AdHoc network."
Using an AdHoc network, you can obtain a network
connection easily and at a low cost.
In the AdHoc mode, you can use the function supported
by Microsoft Network, such as File and Print Sharing to
exchange files and share a printer or other peripheral
devices.
To use the AdHoc Mode, you must set the same SSID
and the same encryption key for all the computers that
are connected. All connected computers can communi-
cate with each other within the communication range.
Infrastructure Mode
If a number of computers are connected simultaneously
in the AdHoc mode, the transfer rate may be reduced,
communications may become unstable, or the network
connection could fail. This is because all wireless LAN
cards are using the same radio frequency in the network.
46
To improve this situation, you can use a wireless LAN
access point, which is sold separately. The wireless LAN
network is in the "Infrastructure mode" when it uses an
access point, and such a connection is called the "Infra-
structure Network."
By using an access point, you can set and use a different
communication channel for each network group. Each
channel is given a different radio frequency, and it
eliminates the collision of communications and provides
a more stable communications environment. Infrastruc-
ture mode is most suitable when you are configuring
multiple wireless LAN networks on the same floor.
To connect a wireless LAN network to a wired LAN, you
need an access point.
How to Handle This Device
The optional Integrated Wireless LAN device is already
installed in ST4000 Series Tablet PC computers that have
been so configured. Under normal circumstances, it
should not be necessary for you to remove or re-install
it. The LAN has been configured to support the oper-
ating system with which your system shipped.
The On/Off switch located on the Wireless LAN cover
turns the device on and off. You should switch the device
off when it is not in use in order to maximize battery life.