Pc Card Slot; Removing And Installing Memory Modules - Fujitsu Stylistic Manual

PC CARD SLOT

The Stylistic Tablet PC Card slot allows you to
install a Type II PCMCIA Card.
Installing a PC Card
To install a PC card, position the side with the
arrow facing up (i.e., when looking at the
tablet's display side, the arrow on the card
should be visible.) Slide the card into the PC
Card slot, and press it firmly to ensure proper
seating. (See Figure 2-5 for location)
If you need assistance to install a PC Card in
the Stylistic Tablet PC, contact your corporate
help desk or reseller.
Figure 2-5 Installing a PC Card
Removing a PC Card
To remove a PC Card, first click the Safely
Remove Hardware icon in the system tray in
the bottom right-hand corner of the display.
Select PC Card from the list, and click [Stop].
Press the PC Card eject button so that it pops
out. Once the button has popped out, press it
firmly to eject the card. (See Figure 2-6 for
location)
Figure 2-6 Removing a PC Card
U s i n g Yo u r S t y l i s t i c Ta b l e t P C
REMOVING AND INSTALLING
MEMORY MODULES
There are 2 DIMM slots in your Tablet PC. One
of them is already occupied by a pre-installed
memory that is shipped with your system while
the other one is empty. 256 MB, 512 MB, and 1
GB modules are available, so you can install a
combination of up to 2 GB in the system.
DIMM replacement should be performed at
a static-free workstation. Do not touch
connector pins, circuit boards, or other
circuit components on the drive or Tablet
PC. Electrostatic discharge caused by
doing so can damage sensitive
components.
Installing a Memory Module
To install a DIMM module in the Tablet PC:
1. Ensure that the Tablet PC is off. To do so,
carry out the Shut Down command in the
Start menu. (Do not attempt to remove or
install a DIMM module when the system is in
Suspend mode or running.)
2. Remove the two screws from the cover plate
on the back of the Tablet PC and remove the
cover plate as shown in Figure 2-7.
Figure 2-7 Accessing the Memory Slot
37