Connecting Windows 2000 Systems - Fujitsu Stylistic 4120 User Manual

CONNECTING WINDOWS 2000 SYSTEMS

This chapter describes how to set the wireless LAN
connection for computers running Windows 2000.
P O I N T
If you purchased a Stylistic ST4000 Series Tablet PC
with the optional integrated wireless LAN device, the
device and drivers have already been installed. This
procedure outlines the steps for setting the device
parameters.
Updated drivers and/or utilities may become available
after this manual is printed; see any addenda or fliers
that may be included in the system packaging.
Workflow
The proper setup of the wireless LAN requires several
steps which must be performed in the proper order.
Following is a general outline of the steps that must be
performed. Each step is detailed later in this procedure.
1. Setting parameters
Setting the profile
Setting the encryption
2. Network settings
Setting the protocol and checking the network
Setting file and printer sharing
Checking the connection
Setting Parameters
1. Click [Start]-> [Settings] -> [Control Panel].
2. Double-click the [PRISM Settings] icon. The
[PRISM Wireless Settings] appears.
3. Set the profile as specified in Table 1. Ask your
network administrators to check the setting.
4. When you finish your entry, click [Apply].
Item
Profile Enter the system file name in which the
parameter information is to be saved.
Mode Ad Hoc Network: Click the down arrow
and select "802.11 AdHoc".
Infrastructure Network: Click the down
arrow and select "Infrastructure".
SSID Enter the network name to which you
want to connect
Transmit Obtain the information from your
Rate network administrator. If you do not have
a network administrator, select "Fully
Automatic".
Description
W i r e l e s s L A N U s e r ' s G u i d e
Item
Power Not supported.
Save
Enabled
AdHoc AdHoc Network: Select the same
Channel channel, 1-11, for all connected
computers. If there is more than one
wireless LAN nearby (such as on the same
floor), we recommend that the channels
for each LAN be 5 numbers apart (e.g., if
there are two other LANs nearby, the
channels used should be 1, 6, and 11).
Infrastructure Network: Not an option.
Table 1: Profile Parameters
5. Click the [Encryption] tab.
6. Set the encryption items in accordance with Table 2.
AdHoc Network: Specify the same value for all the
computers for which the encryption key is used for
connection.
Infrastructure Network: Specify the identical encryp-
tion keys to the encryption keys set for the access
point. For instructions on how to check the encryp-
tion keys set for the access point, refer to the access
point manual.
P O I N T
Make sure that you specify the encryption keys. If you
do not specify the keys, any computer with a wireless
LAN card can be connected. This presents a risk that
your data may be stolen or destroyed.
Item
Encryption Click the down arrow and select an
encryption option.
(WEP)
Disable: Disables the encryption. In
this case, "Create keys with Pass-
phrase" and subsequent items are
greyed out, and you cannot enter
anything.
40 bit*: The encryption is set.
Select either "Create keys with
Passphrase", "Create keys manu-
ally", or "ASCII Input", and enter
the encryption keys.
104 bit*: The encryption is set.
Select either "Create keys with
Passphrase", "Create keys manu-
ally", or "ASCII Input", and enter
the encryption keys.
Description
Description
47