Troubleshooting - Fujitsu Stylistic 4120 User Manual

TROUBLESHOOTING

This section contains troubleshooting information, including causes and actions, for problems you may find while using
this device.
Troubleshooting Table
Problem
An exclamation mark
(!) or cross (x) is
attached to [Intersil
PRISM Wireless LAN
PCI Card].
Other computers are
not displayed when
the [Network
Computer] icon is
double-clicked.
Possible Cause
A failure to Restart the computer.
recognize the device.
A failure in installing Restart the computer.
the driver.
The network has not Check the setting for the protocol, workgroup, and sharing.
been set up correctly.
To check this, you need a different procedure, depending upon the
operating system that you use. Refer to the appropriate section of
this chapter.
It takes time before Perform the following steps to search for the computer.
the network is
searched and the
computer connected
is displayed.
A failure in installing Make sure that the driver is correctly installed.
the driver.
The TCP/IP protocol Make sure that the TCP/IP protocol is installed. To check this, you
is not installed, or, need a different procedure, depending on the operating system that
the IP address is not you use. Refer to the appropriate section of this manual.
set correctly.
The TCP/IP protocol If the TCP/IP protocol is installed, do the following to check the IP
is not installed, or, address:
the IP address is not
1. Windows 2000:
set correctly.
Windows XP:
2. Enter "IPCONFIG" command, and press [Enter].
Check that the IP address is correctly displayed under the IP Address.
Example:
IP address: 10.0.1.3
Subnet Mask: 255.255.255.0
Default Gateway: 10.0.1.1
No communication Shorten the distance between computers or remove visible obstacles
due to poor radio between them, and retry the connection.
signal.
W i r e l e s s L A N U s e r ' s G u i d e
Possible Solution
Click [Start] -> [Search] -> [Other Computers].
Enter the computer name that you are connecting to in [Name],
and click [Search].
Double-click the icon of the computer that has been searched.
Click [Start] -> [Programs] -> [Accessories] -> [Command
Prompt].
Click [Start] -> [All Programs] -> [Accessories] ->
[Command Prompt].
(If your hard disk is C drive, enter
C:\>ipconfig)
55