Epb - Xtool A30D User Manual

5.2 EPB

Electronic Parking Brake (EPB) System reset is a popular special function. You can
use this function to reset the electronic parking brake system and brake pads,
which also supports the brake pad replacement (retraction, release of the brake
pump), G-sensor, and body angle calibration. This function has multiple uses and
can safely and effectively maintain the electronic brake system. These applications
include deactivating and activating brake control systems, assisting in controlling
brake fluid, opening and closing brake pads, and setting brakes after replacing
brake discs or brake pads, etc.
1. If the brake pad wears the brake pad sense line, the brake pad sense line will
send a signal to the onboard tablet asking for replacing the brake pad. After
replacing the brake pad, you must reset the brake pad. Otherwise, the car
alarms.
2. Reset must be performed in the following cases:
The brake pad and brake pad wear sensor are replaced.

The brake pad indicator lamp is on.

The brake pad sensor circuit is short, which is recovered.

The servo motor is replaced.

The operation guidelines of the EPB function are shown as below:
1. Enter the EPB menu and choose relevant models according to the vehicle
being tested.
— 34 —