System Installation - Nortel Communication Server 1000 Fundamentals

50 Installation and configuration
"Mini-Carrier Remote-unique hardware list" (page 51)
component part numbers and descriptions.
•
Install the cabinet, if not already installed. Refer to
cabinet" (page
•
Configure the RMI, NT5D67. Refer to
terminal port" (page
•
Install the RMI into the CPU card slot in the cabinet.
•
Install the power supply.
•
Install the line cards.
•
Connect the NT5D87 RMI Multi I/O cable assembly to the cabinet
connector directly below the RMI.
•
Connect the T1 carrier links and MMI terminal to the RMI Multi I/O
cable assembly. Refer to
cabling" (page 43)
•
Connect the subscriber loops to the appropriate line card connectors.

System installation

Preinstallation preparation
Preinstallation preparation consists of preparing the sites, unpacking and
inspection, taking inventory, selecting the line card slots for the LMI and
LMX(s), selecting the T1 carrier link(s), and preparing the remote site
cables, grounding, power source, and the space for the remote cabinet.
Preparing the sites
When preparing a site, you must address environmental, structural,
and electrical factors. These factors must be considered for the entire
system (that is, local and MCR sites). This information is available in
Communication Server 1000M and Meridian 1 Large System Planning
and Engineering (NN43021-220) and Communication Server 1000M and
Meridian 1 Small System Planning and Engineering (NN43011-220).
To prepare the system for MCR installation, you must first install and verify
the operation of the local system, without linking to the MCR sites. Refer to
Communication Server 1000M and Meridian 1 Large System Installation
and Commissioning (NN43021-310) and Communication Server
1000M and Meridian 1 Small System Installation and Commissioning
(NN43011-310).
62).
67).
for the RMI cabling diagram.
Nortel Communication Server 1000
Mini-Carrier Remote Fundamentals
NN43001-557 04.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
"Configuring the remote MMI
Figure 10 "Remote Mini-carrier Interface
for MCR
"Installing the MCR