Nortel Communication Server 1000 Fundamentals page 74

74 Installation and configuration
Figure 12
HELP (H) screen
Note:
for future use.
ALARM [ENABLE | DISABLE]
ALARM ENABLE (A E)
This command allows MCR to activate system alarm relay output to
respond to any active alarm condition. Its display is similar to
"ALARM ENABLE (A E) screen" (page
Figure 13
ALARM ENABLE (A E) screen
ALARM DISABLE (A D)
This command will prevent the MCR system from asserting its alarm relay
output while in alarm mode. Its display is similar to
DISABLE (A D) screen" (page
Figure 14
ALARM DISABLE (A D) screen
The FIRMWARE and ESAM SAVE commands are reserved
Nortel Communication Server 1000
Mini-Carrier Remote Fundamentals
NN43001-557 04.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
74).
Figure 14 "ALARM
74).
Figure 13