Master/Slave Mode - Ledj LEDJ187 User Manual

DMX mode:
Operating in a DMX control mode environment gives the user the greatest flexibility when it comes
to customising or creating a show. In this mode you will be able to control each individual trait of
the fixture and each fixture independently.
To access the DMX address mode, press the "MENU" button on the rear of the unit to show
the LED display. Now use the "UP" and "DOWN" buttons to set the required DMX address. Press the
"ENTER" button to confirm the setting. The DMX channel mode will now be displayed, use the "UP" and
"DOWN" buttons on the rear of the unit to select either 1 or 2 DMX channel mode.
Press the "ENTER" button to confirm the setting.
To exit out of any of the above options, press the "MENU" button.
1 channel mode:
Channel Value Function
1 000-255 Master dimmer (0-100%)
2 channel mode:
Channel Value Function
1 000-255 Master dimmer (0-100%)
2 000-015 No function
016-255 Strobe (slow-fast)

Master/slave mode:

To set the master unit, press the "MENU" button on the rear of the master unit then select your desired
program (sound active or dimmer modes). To set the other units in slave mode, press the "MENU"
button on the rear of the unit to show
firm the setting. The units will now run in sequence with the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Manual dimming mode:
To access the manual dimming mode, press the "MENU" button until the display shows
the LED display. Use the "UP" and "DOWN" buttons to select the required brightness from
U. 2 55
. To adjust the flash speed press the "ENTER" button and then use the "UP" and "DOWN" but-
tons to select any value from
Value: 000 - 255 (000 = low brightness, 255 = high brightness)
Value: 00 - 15 (00 = no flash, 15 = fast flash speed)
To exit out of any of the above options, press the "MENU" button.
www.prolight.co.uk
SLAu
on the LED display and press the "ENTER" button to con-
F5. 0 0 F5. 1 5
~ . Press the "ENTER" button to confirm the setting.
Operating instructions
100W UV COB Flood User Manual
d. 0 01
on
U. 2 55
on
U. 0 00
~
6