Lamp Settings; Fixture Information; Operation In Automatic Mode; Slave Receive Mode - ProLights SUNBLAST3500MAX User Manual

Off - The brightness increase is linear.
Dimmer 1 - Light intensity control is finer at low level and coarse at high levels.
Dimmer 2 - Light intensity control is finer at high level and coarse at low levels.
Dimmer 3 - Light intensity control is finer at low and high levels, and coarse to medium levels.
- Temperature - Through the Temperature function can be displayed the temperature inside the fixture,
near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.

3.7 LAMP SETTINGS

Factory Reload
Select this function to reset the unit to factory settings:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Advanced icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select Factory Reload and press the ENTER button
to enter the next menu.
• Press the UP/DO

3.8 FIXTURE INFORMATION

To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
- Fixture Time - Through the Time Information function you can display the operating time of the
projector.
- Temperature - Through the Temperature function can be displayed the temperature inside the fix-
ture, near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
- Fans Speed - Through the Fans Speed function you can show on display the fan speed present near
the lamp. Velocity is expressed in RPM (revolutions per minute).
- Software Version - Through Software Version function you can display the currently installed software
version.
• Press the LEFT button repeatedly to exit the menu.
3.9 OPERATIONS IN AUTOMATIC MODE

SLAVE RECEIVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
The Slave unit receives data from the Master unit according to the group which the Slave unit was as-
signed to.
For example, if a slave device is set to Receive Part 1, the Master unit Slave unit will send the automated
Chase Part 1; if set to Receive Part 2, the Chase Part 2 Slave units will receive from the Master.
To set the drive as a slave, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the StandAlone icon, then press the ENTER button
to enter the next menu.
SUNBLAST3500MAX
WN button to select ON or OFF, then press the ENTER button to confirm.
17