Configure Igmp Snooping Port Settings - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.

Configure IGMP Snooping Port Settings

Bridge > IGMP Snooping > Port Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, IGMP Snooping, and Port Settings.
3. Review the settings. Click Apply to save the settings.

Static Router Port – Select Enable for this option to assign a port as a static
router port for IGMP snooping.

Fast Leave – Select Enable to enable the fast leave function on specified port.

Filter Profile – Profile tables can be created to allow or deny a specified range of
multicast addresses. The multicast address range can be created under Bridge >
IGMP Snooping > Address Entry and assigned to profile table to permit or deny
under Bridge > IGMP Snooping > Profile Table.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-30102WS
"Access your switch management page"
39