Configure Mld Snooping Port Settings - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide

Max Response Time – Enter the maximum response time in seconds that client
can wait before responding to a query.

Robustness Variable – Enter the robustness value used to determine the
number of times to send a message.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Configure MLD Snooping Port Settings

Bridge > MLD Snooping > Port Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on MLD Snooping, and click on Port Settings.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
3. Review the settings. Click Apply to save the settings.

Static Router Port – Select Enable for this option to assign a port as a static
router port for IGMP snooping.

Fast Leave – Select Enable to enable the fast leave function on specified port.

Filter Profile – Profile tables can be created to allow or deny a specified range of
multicast addresses. The multicast address range can be created under Bridge >
MLD Snooping > Address Entry and assigned to profile table to permit or deny
under Bridge > MLD Snooping > Profile Table.
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-30102WS
42