Mld Snooping; Configure Mld Snooping Settings; Configure Mld Snooping Table Vlan Parameters - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

MLD Snooping

Configure MLD Snooping Settings

Bridge > MLD Snooping > Basic Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on MLD Snooping, and click on Basic Settings.
3. To enable IGMP Snooping, select Enabled from the drop down menu under MLD
Snooping Global State.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Configure MLD Snooping Table VLAN parameters

Bridge > MLD Snooping > Basic Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge and click on IGMP Snooping.
3. Review the settings. Click Apply to save the settings.

Status – Click the drop-down list and select Enabled to enable the IGMP
snooping feature or Disabled to disable the feature.

Querier Election – Click the drop-down list and select Enabled to enable the
Querier Election or Disabled to disable this feature.

Compatibility – Click the drop-down to select Auto (automatically detect which
IGMP version to use) or force the use of a specific IGMP version.

Querier Interval – Enter the amount of time you want your switch to send
IGMP queries.
TPE-30102WS
"Access your switch management page"
41