TRENDnet TPE-30102WS User Manual page 64

TRENDnet User's Guide
Add ETYPE
To add an ETYPE policy, use the following procedure:

Click Add ETYPE, The Policy Settings page.

Enter a number in the Policy Index field. The Policy Index is a unique number
within the range of 1 – 256 which identifies the policy. This field is mandatory.

Enter a number in the VLAN ID field. A unique number identifying a VLAN
ranging from 1 to 4094.

Enter a number in the 802.1q Priority field. Enter the priority level of the frame
ranging from 0 – 7.

Choose the parameters to add for the policy, and enter data one or more of the
parameters required for your policy. They are listed here:
o
Source MAC Address - Specifies the source MAC address. The format
is xx.xx.xx.xx.xx.xx.
o
MAC Address Mask - Indicates mask for the Source MAC Address. The
format is xx.xx.xx.xx.xx.xx.
o
Destination MAC Address - Specifies the destination MAC address.
The format is xx.xx.xx.xx.xx.xx.
o
MAC Address Mask - Indicates mask for the Destination MAC Address.
The format is xx.xx.xx.xx.xx.xx.
o
Ether Type - Indicates the protocol of the Ethernet frame protocol
ranging from 0600 to FFFF.
o
Policy Action – Indicates if the policy will be Permitted or Denied.
o
Policy Action: In the Permit/Deny field, use the pull down menu to
select one of the following parameters:

Deny - This selection drops ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP.

Permit - This selection allows ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP to be
processed by the switch.
Note: You must enter a selection for Deny/Permit field even if the
Profile Action ID that you have entered ignores both the Replaced-
DSCP and Replaced-CoS fields.
© Copyright 2018 TRENDnet. All Rights Reserved.
o
Rate Control Index: The Rate Control Index is a unique number within
the range of 1 - 65535. This field is mandatory and must match a Port
List Index that has been previously entered on the Policy Index.
o
Ingress Port List: Select the interface for which you want to display data.

Click Add to add the policy to the Policy Table.
TPE-30102WS
60