Table of Contents
Advertisement
TRENDnet User's Guide
Configure IGMP Snooping Address Entry
Bridge > IGMP Snooping > Address Entry
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on IGMP Snooping, and click on Address Entry.
3. Review the settings.
Address Entry Name: Enter the entry ID.
Start IPv4 Multicast Address: Enter the starting IPv4 Address for the IPv4
Multicast Address
End IPv4 Multicast Address: Enter the final IPv4 Address for IPv4 Multicast
Address
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Configure IGMP Snooping Profile Settings
Bridge > IGMP Snooping > Profile Table
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on IGMP Snooping, and click on Address Entry.
3. Select Enable or Disabled from the drop down menu to enable/disable IGMP
Snooping Profile and click apply when completed.
4. Enter the Profile Name and Product Description and click Add when completed.
5. You can review your settings under the IGMP Snooping Profile Table.
4. Click Apply.
TPE-30102WS
"Access your switch management
page"
40
Advertisement
Table of Contents
